Electronically controlled breathing control device
The breath control device has a timer that controls breathing, how long you breathe, and how long you stop breathing. This can be set variably for each user.
A delay timer is installed in the form of a rotary wheel and is used as required so that the subject does not count the seconds when there is air and when the air supply is interrupted.
This is how you can increase the effectiveness of the breath control game.
In addition, the remote control can also be used, which can interrupt the air supply whenever necessary by pressing a button. The timer continues to run in the background without interruption. There are 4 red LEDs installed at the outlet for the air supply to the test subject. This is a visual stimulus and indicates that the air supply is now interrupted.
Optionally, a beep can also be switched on, which gives a signal when the valves open and close.
Two hoses are supplied, one hose connects to the gas mask and the other hose ends at an inhaler, sniff box or just left open if needed.
Safety always comes before lust or, to put it another way, safety is the top priority in this game.
For this reason, a large, yellow and red emergency button has been integrated. When this button is pressed, the power is cut off immediately and all valves are opened. It can therefore be breathed freely. Should it happen that there is a power failure during a session, this was also taken into account. If the current is interrupted, all valves are immediately opened and you can breathe freely.
The breath control device can also be used without the Poppers device, but the Poppers device will not work without the breath control device.
The inhaler and the gas mask in the pictures are not included!
Scope of delivery:
1x breath control device including remote control
2x 105cm rubber hose
Important NOTE!!!
Although the device is fully functional, it is sold for decorative purposes only. We assume no liability for damage to health that you may suffer from using it.
